HMT Rivet Removal Range

The complete range of HMT rivet removal solutions can be seen below and gives solutions for drilling accessible rivets, distance drilling, drilling rivets with obstructed access, enlarging and cleaning out old rivet holes and tight access drilling.

 

VersaDrive TurboTip Pilot DrillBit

6.35mm

High speed, impact and rotary rated drill bit that can be used to pilot drill the rivet and avoid removing the pilot pin from the holecutter

VersaDrive TCT Rivet HoleCutter

55mm Depth of Cut

12 - 80mm Cutting Diameters Available

VersaDrive Extra Long TCT Rivet HoleCutter

100mm Depth of Cut

14 - 26mm Cutting Diameters Available

HoleCutter Pilot Drill Bit

Supplied with the TCT Holecutter and can be used to pre-drill the rivet head, allowing the holecutter pilot pin to centre the holecutter during the main cut

HoleCutter Pilot Pin

Used to guide, stablise and centre the HoleCutter during the main cut. Whilst the pilot drill bit can also be used for this, the solid pin is less prone to breakage if the HoleCutter ‘snags’.

CarbideMax TCT Broach Cutter

40mm - 110mm Depth of Cut

12 - 80mm Cutting Diameters Available

CarbideMax Extra Long TCT Broach Cutters

Up to 200mm Depth of Cut

18 - 200mm Cutting Diameters Available

VersaDrive Impact Reamer

11mm VersaDrive Shank

8 - 26mm Cutting Diameters Available

VersaDrive MAX Impact Reamer

20mm VersaDrive MAX Shank

18 - 41mm Cutting Diameters Available

Speedlube Aerosol Lubricant

High performance, aerosol propelled lubricant that foams on contact to ensure maximum tool coverage and heat dissipation

OverReach System

Position Magnetic Drills in otherwise inaccessible locations

V35 Compact Magnet Drill

Lightweight, flexible mag drill with 110mm cutting depth & seamless integration with the VersaDrive® system

RTQ40 Low Profile Magnet Drill

Ideal for tight access applications

Suitable for use with any standard broach cutter up to 40mm cutting depth

VersaDrive Impact Wrench Adapter

Available in 1/2" and 3/4" drive sizes

Converts Impact Wrenches for use with VersaDrive® TurboTips and Impact Reamers

VersaDrive Magnet Drill Adapter

19.05mm (3/4") Weldon Shank (fits all standard mag drills)

Magnet Drill Adapters are available to allow TCT Holecutters to be used as an annular cutter in a Standard Magnetic Drill

VersaDrive 130mm Extension Arbor

VersaDrive extension arbors are available in 130mm & 300mm working length to assist reach in confined or otherwise inaccessible locations such as corners

VersaDrive 300mm Extension Arbor

VersaDrive extension arbors are available in 130mm & 300mm working
length to assist reach in confined or otherwise inaccessible locations such as corners

VersaDrive SDS+ Adapter

SDS Adapters convert VersaDrive HoleCutters for use in SDS+ Drills in Rotary only mode



Scroll To Top